There are several ways to groom your horse in order to be bet on at online casino sa. You should always try to apply shampoo thoroughly and rinse it off well once finished. Using a conditioner keeps hair soft and adds shine. Lastly, using brushes is essential to remove dirt from your horse's body. Now, let's get into detail.
How to Make Your Horse Shiny
1. Brush Away Loose Hair
First, start by brushing away the loose hair around the horse's mouth. This includes any excess hay or grass that may have gotten stuck there due to their chewing habits. Then use an appropriate brush to do this. You can find proper brushes at most pet stores.
2. Use a Sponge
Next, clean underneath the horse's chin with a sponge. Use a lather to make sure you cover all the dirty areas. Remember to avoid getting soap/water in the animal's eyes. After cleaning up, dry him down with a towel or blowdryer. It will help reduce mats and prevent chipping paint on the horse's coat. If he needs more intense attention, ask someone else to help. A groomer usually does a very thorough job.
3. Brush Out Excess Hair
Once you're done cleaning under his chin, it's time to brush out the dirt that got trapped underneath his jaw. Take another scrub brush and gently brush this area until it looks nice and smooth before your online blackjack. Once finished, you can either leave it as is or give it a quick spray. You want to be careful about water spills since they could cause damage to your horse's skin.
4. Brushing Down the Body
You can now move on to brushing the rest of the horse. Start by using a slicker brush (the style you'd normally see on a car) and brush through large sections of the horse's body before moving on to smaller sections. Do this slowly so the horse doesn't feel uncomfortable while you're doing it. When using the slicker brush, focus on keeping the end curled up.
For example, if you've got long legs, curl the ends up and shorten the length of the handle. You'll notice that the brush moves much easier when doing this. Also, be mindful not to pull too hard. Don't force your horse, but just brush through in small movements instead.
5. Shampooing the Mane
Now it's time to wash the mane. Start by pulling the tail towards the ground and carefully roll it over. Be sure to put some pressure on its back end. Next, take a toothbrush and gently hold up the mane while spraying it with warm water. Try to get rid of any knots or tangles without hurting the horse. Once you finish washing the mane, pat it lightly with a towel. It's best to keep your hand low so the mane doesn't come in contact with itself.
6. Brushing the Manes
Now that the mane has been cleaned with warm water, it's time to set up your brush again. However, this time, brush along the top first then follow by brushing through the middle section. Go slowly so you don't hurt the animal and don't push too hard.
7. Brushes Up Again
After finishing the mane, use your brush to go over the entire body. In particular, pay close attention to areas like the chest, neck, and sides. Finish off by using your slicker brush to brush off any extra dirt from around the horse.
8. Blow Dry Your Horse
After you're finished brushing, you should move on to blow-drying your horse. Grab a hair dryer and press it against the horse's fur only for a few seconds. Repeat this process until the entire body is nicely dried and you can finally move on to the next part: clipping!
Photo: Pixabay (free)